Fixed issue where simulation shows additional stock when 'No Additional Stock' is selected in the setup (#9385)įixed issue in Turning Grooving where the reduced feedrate was using feed/min instead of feed/rev mode (same as cutting- feedrate mode) (#9337).Fixed issue where rest machining does not calculate when preceded by a manual NC operation in turning operations (#9499).Fixed crash when creating 2 Manual NC commands (#9494).Fixed issue where tool is not always taken to limit when rewind is required (#9559).Changed guided deep drilling to use retract feedrate (#9310).Fixed wrong multi-axis handling for feed optimization.Fixed out of memory error when using nested patterns with the Excel Setup Sheet (#3115).

Added error that is shown when thread mill pitch * teeth exceeds flute length (#9374).

Beta Added support for Machine Configurations (#7745).

Added support for tapered walls in 2D Adaptive (#9201).

Added support for 'Select Same Diameter' on sketches in Drilling (#9435).

Added containment boundary support to Drilling (#8958).

Added diameter range support to Drilling (#8956).

Added support for selecting rest material source 'from bodies' (a.k.a.Added Tool Orientation to Probing (#9410).Added Both-Ways Adaptive Clearing (#6890).This release contains a number of important fixes and improvements, as identified below. Inventor HSM Ultimate (formerly Inventor HSM Pro).Inventor HSM Premium (formerly Inventor HSM).This document covers all three Inventor HSM products: Autodesk® Inventor HSM™ 2019 Release Notes

Autodesk inventor hsm ultimate